User's Manual

C3648M (7/08) 5
Important Safety Instructions
The DX8100-ISCI SCSI card must be installed inside the DX8100 chassis. To do so, the DX8100 must be taken offline and turned off before
starting the upgrade process. Before continuing the upgrade procedure, read these safety instructions.
1. Read the Important Safety Instructions that came with the DX8100. You can access this document at www.Pelco.com. Navigate to
Products > Control Site Equipment > Video Recorders > Digital Video Recorders > DX8100 Series Digital Video Recorders > Documents.
2. The security surveillance service provided by the DX8100 is interrupted when it is taken offline.
3. The unit must be shut down and turned off to install the DX8100-ISCI SCSI card.
4. Unplug the power cord from the wall socket, and then unplug it from the rear of the DVR.
5. Only use attachments/accessories specified by the manufacturer.
6. Make sure you protect the unit and its components from electrostatic discharge (ESD).
7. The currently installed data drive(s) might contain recorded data. If you must remove a data drive, label the drive to make sure it is
reinstalled in the same location.
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage constituting a risk of electric shock is
present within this unit.
This symbol indicates that there are important operating and maintenance instructions
in the literature accompanying this unit.
Regulatory Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
You may also find helpful the following booklet, prepared by the FCC: “How to Identify and Resolve Radio-TV Interference Problems.” This
booklet is available from the U.S. Government Printing Office, Washington D.C. 20402.
Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commission’s rules.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
WARNING: It is critical that the DX8100 be unplugged for your safety. You must remove the power cord because electrical current
continues to flow through the unit even when it is off.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.