I N S T A L L A T I O N SWM4-W Pendant Wall Mount C2223M (1/06)
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Only use attachments/accessories specified by the manufacturer. 6. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 7.
Installation The following parts are supplied: 1 Adapter plate with locking screw 1 Pendant wall mount 2 8-32 x 0.75-inch screws To install the SPM4-W pendant mount: 1. Run 24 VAC power, video (coax or UTP), and camera control wiring to the mounting location. If using coax video, attach a female BNC connector to the coax cable. Refer to Figure 6, Table D, Table E, and Table F in the installation manual for the Spectra Mini dome for wiring information.
2. Thread the 24 VAC power, video (coax or UTP), and control wiring through the large access hole in the adapter plate. Then attach the adapter plate to the mounting surface using either the top/bottom or left/right pair of mounting holes. (The top/bottom pair is shown in Figure 2.) NOTE: If mounting to anything other than a junction box, please select appropriate mounting hardware for the mounting surface Figure 2.
3. Thread the wiring through the pendant wall mount, and then attach the mount to the adapter plate: a. Locate the mount hooks in the mount. Hang these hooks onto the adapter plate guides. b. Make sure all wires are enclosed in the mount. c. Rock the mount into place. 3a 3b 3c Figure 3.
4. Lock the mount: a. Locate the slide lock at the base of the mount. Slide it to the right to secure the mount. b. Turn the locking screw counterclockwise until the slide lock is secured. 4a 4b Figure 4. Locking the Mount 5. 6 Install the Spectra Mini dome in the mount. Follow the instructions in the Switch Settings and Hard Ceiling installation sections of the installation manual for the Spectra Mini dome system. In the Hard Ceiling section, disregard step 2 about cutting holes in the ceiling.
Specifications MECHANICAL Mounting Method Attach the mount to wall; attach Spectra Mini dome with the hardware supplied with the mount. GENERAL Construction Mount Adapter Plate ABS plastic Aluminum Finish White Weight 0.72lb (0.33 kg) 3.70 (9.40) 5.20 (13.21) Ø 6.10 (15.49) 7.05 (17.91) NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).