Installation Guide

4
CONTEMPORARY WALL MOUNT TUB FAUCET
Notes:
1. Please ensure all local plumbing and building codes are observed when installing
these faucets.
2. Mounting location depends on tub design and location. Be sure to identify tub height
when determining faucet location.
3. There must be a minimum of 2" gap between top of tub rim and bottom of the faucet
spout to comply with plumbing codes.
4. Water supply lines must be roughed in on 8” centers.
Step 1- Install #1 spout into faucet
body by pushing straight down. Align
spout facing forward then tighten with
#3 Allen screw (packaged separately
with #7 Allen wrench). Do Not Over
Tighten.
Step 2- Screw #16 handle hub
onto hot/cold cartridges #9 & #17.
Disassemble handle by unscrewing
spokes and install onto cartridge
by securing with screw included.
Reassemble handle.
NSF /ANSI 61
C-HLVR
17
16
Screw
Spokes
Spokes
9
16
C-HCRS
1
7
(Allen Wrench)
3