Installation Guide

10
Door Closers continued
10J Rest the door closer bracket on
the screen head cover for vertical
placement.
10L Rest the door closer bracket on the
screen head cover, and position the end
of the door closer bracket.
10M Install the top closer bracket with
two door closer bracket screws (#10 x
5/8" Phillips pan head) from Bag F.
Discard spacer clip from the closer rod.
10N Open the door and check closer
speed. Turning the adjustment
screw to adjust speed of each closer.
Turn the screw clockwise to reduce
closer speed or counter clockwise to
increase closer speed.
10I Attach the door closer bracket to
the door closer by removing the O-ring
from the long closer pin, inserting the
pin, and securing with the O-ring.
Adjustment
Screw
F
a
s
t
e
r
-
S
l
o
w
e
r
Bracket must rest
on top edge or
head cover
Bracket must rest
on top edge or
head cover
d
evomeR
Insert
Door Closer
Long Spacer Clip
Door
Closer
Bracket
Adjustment
Screw
Long Closer
Pin
Short Closer Pin
ROOD MROTS
Door Closer
Rod
Jamb
Closer
Bracket
?
????
1/4"
back
Jamb Closer
Bracket Screws
Jamb
Closer
Bracket
Operating the One-Touch
®
Button:
Tap the button and open the door. To close, nudge the door open slightly.
#10x1-1/2 in.Painted
Painted #10x5/8 in.
10K Slide closer jamb bracket tight against door jamb.
Holding the closer level, position the jamb closer bracket
against the entryway jamb. Ensure the jamb closer bracket is
1/4" back from the hinge side mounting frame.
Install the jamb closer bracket using four jamb bracket
screws (#10 x 1-1/2" Phillips pan head) from Bag E.
Note: Temporarily removing the door jamb bracket from the
closer may make installation of the bracket easier.
10H Attach the top closer rod to the
jamb bracket using the short closer pin
from Bag E, then pull the door closer
and slide the LONG spacer clip onto
the closer rod.
Long Closer Pin
Long Spacer Clip Short Closer Pin
ROOD MROTS
evomeR
dna
dracsiD
Spacer Clip