Installation Guide

Latch
Mounting
Frame
Door
Hinge
Mounting
Frame
Top Mounting Frame/
Drip Cap
Closer Kit
Includes mounting
screws, expander screws
and some handle component
s
Bottom Expander
Extenders
Registration
Number
This is your door’s
identification number.
Leave this sticker on
the mounting frame.
Installation Kit
Includes mortise lock body,
edge cover, deadbolt
screw and 7/8” spade bit
Retractable Screen
Handle Kit
2
Storm Door Components
NOTE: Actual door styles may vary from illustrations, however, the installation steps will be the same.
Before you begin
Make sure brickmold trim is in good condition and securely fastened before beginning installation.
It is highly recommended that additional fasteners be used to reinforce brickmold trim.
Shimming may be required to fit existing opening (shims not included). Measure the width of the opening in
three locations. Using the smallest measurement, refer to the chart below and shim as needed.
1 in. wide x 1 in. deep mounting surface is required.
Standard
Door Sizes
Min–Max
Opening Width
Min–Max
Opening Height
32 in x 81 in 31-7/8 to 32-3/8 in
80 to 81 in
36 in x 81 in 35-7/8 to 36-3/8 in
1 in.
1 in.
TOP VIEW
Exterior Brick Mold Trim
Storm Door Opening Width
Jamb
Primary House Door