Installation Guide

5
4A Slide rail extender into the
bottom of the hinge rail.
5A Place the drip cap on the
door frame above the storm
door.
4E Install door installation screws from
Bag B on the inner side of hinge rail
in remaining locations. Do not over
tighten screws.
Attach Storm Door to Door Frame (Right Hinge shown)
Install the Drip Cap
4
5
4B Hang storm door onto door
frame using the placeholder
screw. The door will settle
approximately 1/16". Tighten
screw while pushing top of
hinge rail tight against the
door frame.
5B Close door to verify
consistent clearance. Align
drip cap to end of hinge rail.
4F Push door tight against door frame
and install screws from Bag C on the
outer side of hinge rail.
Do not over tighten screws.
4C At the second hinge from
the bottom, install a door
installation screw from Bag
B in one of the pre-punched
holes. Do not over tighten.
5C Install screws from
Bag C.
4G Cut extender weatherstripping
to length, peel adhesive backing and
install.
4D Slide rail extender to sill.
Loosen hinge rail screw as
needed.
5D Caulk if desired.
#8x1 in
painted
#8x1 in
painted
#8x3/4 in
painted
#8x3/4 in
painted
Push