Datasheet

Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany
Pepperl+Fuchs Group • Tel.: Germany [phone] • USA [phone] • Singapore [phone] • Internet http://www.pepperl-fuchs.com
Ultrasonic sensor UB200-12GM-E5-V1
3
Release date: 2009-12-11 09:20 Date of issue: 2009-12-11 182234_ENG.xml
• Set target to far switching point
• TEACH-IN switching point A1 with -U
B
TEACH-IN switching point, normally-open function
• Set target to near switching point
• TEACH-IN switching point A2 with +U
B
• Cover sensor with hand or remove all objects from sensing range
• TEACH-IN switching point A1 with -U
B
TEACH-IN switching point, normally-closed function
• Set target to near switching point
• TEACH-IN switching point A1 with -U
B
• Cover sensor with hand or remove all objects from sensing range
• TEACH-IN switching point A2 with +U
B
TEACH-IN detection of objects presence
• Cover sensor with hand or remove all objects from sensing range
• TEACH-IN switching point A1 with -U
B
• TEACH-IN switching point A2 with +U
B
Default setting of switching points
A1 = blind range, A2 = nominal distance
LED Displays
Installation conditions
If the sensor is installed at places, where the environment temperature can fall below 0 °C, for the sensors fixation, one of the
mounting flanges BF 12, BF 12-F or BF 5-30 must be used. In case of direct mounting of the sensor in a through hole, it has to
be fixed at the middle of the housing thread.
Displays in dependence on operating mode Red LED Yellow LED
TEACH-IN switching point:
Object detected
No object detected
Object uncertain (TEACH-IN invalid)
off
flashes
On
flashes
off
off
Normal operation off Switching state
Fault on Previous state