Manual

Fig. No. 0928 Series Regular Bevel with Box Strike

Fig. No. 0930 Series Reverse Bevel with Flush Strike

Fig. No. 1028 Series Reverse Bevel with Box Strike

Fig. No. 1030 Series Regular Bevel with Flush Strike

MOUNTING INSTR

UCTIONS

These Rim Latch Sets are designed to be mounted on the surface of doors 5/8 inch to 1-3/8 inches thick.

1). Cut out the template below. Fold on the dotted line. Place on door at desired height on the side to

have the rim latch. Folded tab should overlap edge.

2). Mark center of circle for drilling.

3). Drill 9/16 inch hole through center.

4). Inset lever handle with shaft through the rim latch. Put shaft through the hole drilled in step #3 above,

align and fasten rim latch to door with #6 screws (Not Supplied). Place escutcheon plate over the

shaft on opposite side of door. Align and fasten with #6 screws (Not Supplied). Thread the knob on

shaft and tighten set screw on knob.

5). Mount strike on door frame.

PERKO, Inc.

16490 N.W. 13th Avenue

Miami, FL 33169

www.perko.com

MOUNTING TEMPLATE

10/04

CAT. NOS.

0928000CHR

0928DP0CHR

0930000CHR

0930DP0CHR

1028000CHR

1028DP0CHR

1030000CHR

1030DP0CHR

9/16” HOLE

1-3/8”

FOLD OVER EDGE OF DOOR

(SEE OVER)

PAGE 1
Fig. No. 0928 Fig. No. 0930 Fig. No. 1028 Fig. No. 1030 Series Series Series Series Regular Bevel with Box Strike Reverse Bevel with Flush Strike Reverse Bevel with Box Strike Regular Bevel with Flush Strike MOUNTING INSTRUCTIONS These Rim Latch Sets are designed to be mounted on the surface of doors 5/8 inch to 1-3/8 inches thick. 1). Cut out the template below. Fold on the dotted line. Place on door at desired height on the side to have the rim latch. Folded tab should overlap edge. 2).
PAGE 2
EXPLODED VIEW CAT. NOS. 0928, 0930, 1028 AND 1030 SERIES LATCH SETS REPLACEMENT PARTS Complete Latch Set 0928000CHR 0928DP0CHR 0930000CHR 0930DP0CHR 1028000CHR 1028DP0CHR 1030000CHR 1030DP0CHR LEVER “L” HANDLE Knob “L” Handle and Shaft Assy. Escutcheon Plate Only Latch Set Body Assy.