Network Router User Manual

IOLAN Device Server User’s Guide, Version 1.0 111
Troubleshooting Appendix A
A
Introduction
This chapter provides information that can help resolve problems with the Device Server.
Hardware Problems
If the Device Server Power/Ready LED is red and stays red for over 10 seconds, you have a hardware
problem that is going to require factory service. If you purchased the Device Server less than 30 days
before this problem appears, contact your distributor; otherwise, see the Perle web site
(
www.Perle.com) for factory service information. Note: no factory service can be done on a Device
Server that has not been registered.
Communication Issues
General communication checks and practices are as follows:
z Are your cables connected and correctly configured? If you are using EIA-232, see EIA-232
Cabling Diagrams on page 27 to verify that your cables are correctly configured.
z Ping your host? If you can ping but packet loss is reported, ping another host/device on the same
network. This will tell you whether the problem is specific to the host/device or general to the
network.
z After entering or changing IP information for your Device Server, reboot the Device Server
(does not apply when using BOOTP or DHCP). Once the Device Server has rebooted, other
network devices should be able to communicate with it (ping, telnet, etc.). Also, protocols such
as ARP and proxy-ARP will work properly.
z Use the show routes command (command line only) or view the Routes statistics. Is there a
route to the host?
z If the WebManager or DeviceManager cannot communicate with the Device Server, verify that
the
Server Services HTTP is enabled for WebManager and DeviceManagerD is enabled for
DeviceManager.