Network Router User Manual
Table Of Contents
- IOLINK-520 and IOLINK-PRO USER AND SYSTEM ADMINISTRATION GUIDE
- Installation
- Typical Applications & How to Configure Them
- 2.1 - Bridging and Routing
- Should You Bridge or Route?
- 2.2 Basic WAN Configurations
- 2.3 - Configure Remote Site Profiles
- 2.4 Advanced Features
- Introductionto Filtering
- Appendix AMenu Trees
- Appendix BOctet Locations on Ethernet Frames
- Appendix CServicing Information
- Opening the case
- Identifying the Internal Components
- To Clear a “Lost” Password
- Changing LAN or WAN Interfaces
- Selecting MDI or MDI-X LAN Interface
- Installing the ISDN Link Modules
- Processor settings for the ISDN Link Modules
- Changing the Termination Straps on the ISDN S/T Interface
- Connecting to the ISDN-U Link Module
- Performing a Software Upgrade
- Appendix DInterface Pinouts
- Pinout Information
- Link Clocking Information
- ATL-CSU/DSU Link Module Information
- Console Pinouts
- V.24 & RS232C Link Pinouts
- V.11/X.21 Link Pinouts
- RS442 & RS530 Link Pinouts
- V.35 Link Pinouts
- RS232 Null-Modem Cable Configuration
- V.35 Null-Modem Cable Configuration
- RS530 Null-Modem Cable Configuration
- RS530 To RS449 Conversion Cable
- V.11/X.21 Null-Modem Cable Configuration
- Index
- Warranty
Applications
IOLINK-520 & IOLINK-PRO Installation & Applications Guide —
2.15
2.1.4.4 - Multilink Operation
Multilink operation defines the use of more than one link to connect between two PPP
routers. When a multilink connection is required, simply enable the
Multilink Operation
option of the remote site profile for that connection.
When a multilink connection is established, the multilink (MP) options within the PPP set-
up and Advanced PPP set-up menus will determine the operation of the multilink
connection.
Location:
Main
!
Configuration
!
Connections Set-up
!
Remote Site Set-up
!
Edit Remote Site
!
Protocol Set-up
!
Multilink
Enabled
"
""
"