Network Router User Manual
Table Of Contents
- IOLINK-520 and IOLINK-PRO USER AND SYSTEM ADMINISTRATION GUIDE
- Installation
- Typical Applications & How to Configure Them
- 2.1 - Bridging and Routing
- Should You Bridge or Route?
- 2.2 Basic WAN Configurations
- 2.3 - Configure Remote Site Profiles
- 2.4 Advanced Features
- Introductionto Filtering
- Appendix AMenu Trees
- Appendix BOctet Locations on Ethernet Frames
- Appendix CServicing Information
- Opening the case
- Identifying the Internal Components
- To Clear a “Lost” Password
- Changing LAN or WAN Interfaces
- Selecting MDI or MDI-X LAN Interface
- Installing the ISDN Link Modules
- Processor settings for the ISDN Link Modules
- Changing the Termination Straps on the ISDN S/T Interface
- Connecting to the ISDN-U Link Module
- Performing a Software Upgrade
- Appendix DInterface Pinouts
- Pinout Information
- Link Clocking Information
- ATL-CSU/DSU Link Module Information
- Console Pinouts
- V.24 & RS232C Link Pinouts
- V.11/X.21 Link Pinouts
- RS442 & RS530 Link Pinouts
- V.35 Link Pinouts
- RS232 Null-Modem Cable Configuration
- V.35 Null-Modem Cable Configuration
- RS530 Null-Modem Cable Configuration
- RS530 To RS449 Conversion Cable
- V.11/X.21 Null-Modem Cable Configuration
- Index
- Warranty
Applications
IOLINK-520 & IOLINK-PRO Installation & Applications Guide —
2.25
The following steps must be performed on each of the IOLINK routers in the network.
Local IP Address
Location: Main
!
Configuration
!
Interfaces Set-up
! LAN Set-up
!
LAN IP Set-up
!
IP Address / mask size
This is the IP address and subnet mask for the link of this IOLINK
router in the unnumbered IP connection.
Usually the clocking signal is received from the link (see Appendix D -
Link Clocking Information). If the link interface is a V.11, V.35 or
RS232 connection and the link speed is different from the default
(64Kbps), and the IOLINK router is to be the clock source, the link
speed must be set to the clock speed that the IOLINK router receives
from the DCE link device.
Link Speed
Location: Main
!
Configuration
!
Interfaces Set-up
!
WAN Set-up
!
Link Set-up
!
Link Speed
2.2.3.1.1 - Bridge Connection
Once the link speeds have been configured, the IOLINK router will attempt to establish the
link connection to the remote site PPP router. The Bridge connection does not require any
configuration for operation.
2.2.3.1.2 - IP Router Connection
Once the link speeds and local IP address have been configured, the IOLINK router will
attempt to establish the link connection to the remote site PPP router. The IP connection is
an unnumbered connection that requires only the configuration of the IP address of the
IOLINK router.
2.2.3.1.3 - IPX Router Connection
Once the link speeds have been configured, the IOLINK router will attempt to establish the
link connection to the remote site PPP router. The IPX connection is an unnumbered
connection that does not require any configuration.
If security is required for the direct dial connection refer to the Configure PPP Security section
for information on setting the security passwords and user names for PPP.
"
""
"
"
""
"