Network Router User Manual
Table Of Contents
- IOLINK-520 and IOLINK-PRO USER AND SYSTEM ADMINISTRATION GUIDE
- Installation
- Typical Applications & How to Configure Them
- 2.1 - Bridging and Routing
- Should You Bridge or Route?
- 2.2 Basic WAN Configurations
- 2.3 - Configure Remote Site Profiles
- 2.4 Advanced Features
- Introductionto Filtering
- Appendix AMenu Trees
- Appendix BOctet Locations on Ethernet Frames
- Appendix CServicing Information
- Opening the case
- Identifying the Internal Components
- To Clear a “Lost” Password
- Changing LAN or WAN Interfaces
- Selecting MDI or MDI-X LAN Interface
- Installing the ISDN Link Modules
- Processor settings for the ISDN Link Modules
- Changing the Termination Straps on the ISDN S/T Interface
- Connecting to the ISDN-U Link Module
- Performing a Software Upgrade
- Appendix DInterface Pinouts
- Pinout Information
- Link Clocking Information
- ATL-CSU/DSU Link Module Information
- Console Pinouts
- V.24 & RS232C Link Pinouts
- V.11/X.21 Link Pinouts
- RS442 & RS530 Link Pinouts
- V.35 Link Pinouts
- RS232 Null-Modem Cable Configuration
- V.35 Null-Modem Cable Configuration
- RS530 Null-Modem Cable Configuration
- RS530 To RS449 Conversion Cable
- V.11/X.21 Null-Modem Cable Configuration
- Index
- Warranty
Applications
2.28
— IOLINK-520 & IOLINK-PRO Installation & Applications Guide
1 b) Defining this remote site profile within the IP Address connect table, which will
cause a call to be made when a packet for this IP address is routed,
Location: Main
!
Configuration
!
Connections up
!
IP Address Connect
!
IP Address Connect
Enabled
1 c) Defining the Auto-Call option within the Edit Remote Site menu of this remote site
profile. (The Auto-Call option causes the IOLINK router to attempt to establish a
connection to this remote site profile each time the IOLINK router starts up.)
Location: Main
!
Configuration
!
Connections up
!
Remote Site Set-up
!
Edit Remote Site
!
Connection Set-up
!
Auto call
Enabled
1 d) Setting up an activation schedule with times the connection is to be activated and
deactivated
Location: Main
!
Configuration
!
Connections up
!
Remote Site Set-up
!
Edit Remote Site
!
Activation
!
Schedule
Activation intervals
1 e) If a second ISDN channel is available and traffic level is enabled, setting the traffic
load at which the second channel is to be activated.
Location: Main
!
Configuration
!
Connections up
!
Remote Site Set-up
!
Edit Remote Site
!
Activation
!
Threshold
Up Threshold
Down Threshold
Up Stability timer
Down Stability timer