Network Router User Manual
Table Of Contents
- IOLINK-520 and IOLINK-PRO USER AND SYSTEM ADMINISTRATION GUIDE
- Installation
- Typical Applications & How to Configure Them
- 2.1 - Bridging and Routing
- Should You Bridge or Route?
- 2.2 Basic WAN Configurations
- 2.3 - Configure Remote Site Profiles
- 2.4 Advanced Features
- Introductionto Filtering
- Appendix AMenu Trees
- Appendix BOctet Locations on Ethernet Frames
- Appendix CServicing Information
- Opening the case
- Identifying the Internal Components
- To Clear a “Lost” Password
- Changing LAN or WAN Interfaces
- Selecting MDI or MDI-X LAN Interface
- Installing the ISDN Link Modules
- Processor settings for the ISDN Link Modules
- Changing the Termination Straps on the ISDN S/T Interface
- Connecting to the ISDN-U Link Module
- Performing a Software Upgrade
- Appendix DInterface Pinouts
- Pinout Information
- Link Clocking Information
- ATL-CSU/DSU Link Module Information
- Console Pinouts
- V.24 & RS232C Link Pinouts
- V.11/X.21 Link Pinouts
- RS442 & RS530 Link Pinouts
- V.35 Link Pinouts
- RS232 Null-Modem Cable Configuration
- V.35 Null-Modem Cable Configuration
- RS530 Null-Modem Cable Configuration
- RS530 To RS449 Conversion Cable
- V.11/X.21 Null-Modem Cable Configuration
- Index
- Warranty
Applications
IOLINK-520 & IOLINK-PRO Installation & Applications Guide —
2.43
Now the selection rules used to test each packet against are set
IPSec ESP SA
Location: Main
! Configuration
! Packet Services Set-up
! IP Security Set-up
! Policy Set-up
! Edit Item
item_name
! Selection Rules
! Src IP
10.10.10.1 (25)
! Dest IP
192.168.10.1 (24)
! Protocol
any
! Src port
any
! Dest Port
any
The example policy items for Router 1 show the source and destination specified
by the local IP addresses with masks. All protocols will be allowed between all
ports.
Then the policy item must be activated.
IPSec ESP SA
Location: Main
! Configuration
! Packet Services Set-up
! IP Security Set-up
! Policy Set-up
! Edit Item
item_name
! Activate
If packets are to be checked against more than one policy item, tab back to the Policy set-up menu
and repeat the previous steps for the next policy item. There may be up to 32 policy items. Packets
are tested against policy items in order of the items’ priority numbers, from lowest to highest.
"
""
"
"
""
"