Use and Care Guide Signature Series C-Series ADA-Compliant Series Shallow-Depth Series (excludes Beer Dispenser Models) 18” Shallow-Depth Series Beverage Center/48” Signature Series Refrigerator / Wine Reserve stacked on a 48” Signature Series Freezer / Refrigerator Drawers Form No.
Use and Care Guide TABLE OF CONTENTS General Information ................................................................................................................................. 2 Safety ...................................................................................................................................................... 3 Operation .................................................................................................................................................
Use and Care Guide SAFETY Indicates a hazard that WILL result in serious injury or death if precautions are not followed. Indicates a hazard where minor injury or product damage may occur if precautions are not followed. CAUTION DANGER Indicates a hazard MAY cause serious injury or death if precautions are not followed. WARNING OPERATION This is located on the back wall of the unit to the left of the light; in the Signature Series, it is in front on the control cradle.
Use and Care Guide temperature will be displayed. Digital Temperature Control (Signature Series – 15”, 24” & 48” Single Zone) Changing the Lower Compartment Temperature 1. Press and hold the SET button until the display shows St1 with “F” flashing. C F 2. Press SET again to display the lower compartment’s current temperature (“F” will continue to flash). Figure 2. Digital Temperature Controller Changing the Upper Compartment Temperature To Set Target Temperature 1.
Use and Care Guide Key Combinations LED Functions Press the UP and DOWN arrow buttons simultaneously to lock and unlock the keyboard. The following table describes the LED functions. + LED Mode Function ON Compressor is on. Flashing Anti-short cycle delay is on. ON Defrost is on. ! ON An alarm is on. °F Flashing You are in the process of programming the unit. SET + Press the SET and DOWN arrow buttons simultaneously to enter programming mode.
Use and Care Guide Shallow Depth Factory Temperature Setpoint HH24RS 38° F HH24BS 42° F HH24WS 55° F 4. Clean the condenser by using a vacuum cleaner to remove loose debris (leaves, dirt, etc.) that may have accumulated inside the grille. 5. Reinstall the front grille. Adjust the temperature as follows: 6. Clean the interior of the unit using stainless steel cleaner and polish. Colder Temperature: Turn the adjusting screw clockwise (to the right). 7.
Use and Care Guide MAINTENANCE Chlorides are found nearly everywhere. They are in water, food and table salt. Household and industrial cleaners are the worst offenders. Never attempt to repair or perform maintenance on the unit until the main electrical power to the unit has been disconnected! DANGER Preventing Stainless Steel Rust Light Bulb Replacement (C-Series, ADACompliant & Shallow-Depth) Use the proper tools. Use non-abrasive tools to clean stainless steel products.
Use and Care Guide Cleaning Cabinet Interior/Exterior Cleaning the Condenser NEVER use hydrochloric acid (muriatic acid) on stainless steel. Do not use abrasive cleansers or cloths on any interior or exterior surfaces or removable parts. The condenser (located behind front grille cover) should be cleaned every three (3) months. Use a soft bristle brush and vacuum to remove the dust and lint. CAUTION CAUTION Glass panels may be cleaned using any standard glass cleaner available on the market.
Use and Care Guide TROUBLESHOOTING Before Calling For Service If the unit appears to be malfunctioning, read through the Operation section in this manual first. If the problem persists, check this troubleshooting section to see if you can refer to the cause and remedy of the problem and resolve it without a service call. DANGER Never attempt to repair or perform maintenance on the unit until the main electrical power to the unit has been disconnected! Problem No interior light.
Use and Care Guide Problem Compartments are warmer than usual. Cause Solution - Control preset is set to warm. - Lower the setpoint temperature. Refer to changing the setpoint for the specific model. - Light is staying on. - Turn the manual light switch off. - Condenser is dirty or obstructed. - Clean the condenser and clear obstruction. - The door is open or has been opened more frequently lately. - Wait 24 hours and recheck the temperature. - Internal louvers and/or the fan guard is obstructed.
Use and Care Guide RESIDENTIAL PRODUCTS WARRANTY PERLICK RESIDENTIAL REFRIGERATION PRODUCTS LIMITED WARRANTY (excludes H50IM Clear Ice Makers) ENTIRE PRODUCT - Full Three Year Warranty: For three (3) years from date of original purchase, Perlick Corporation’s warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in material and workmanship. You must register your product within 90 days of purchase to receive the Full Three Year Warranty.
8300 West Good Hope Road • Milwaukee, WI 53223 • Toll Free 800.558.5592 • Fax 414.353.7069 • www.bringperlickhome.
