Installation Guide

IMPORTANT
Gate must be installed in a structurally sound opening. Ensure mounting surface
(wall, door frame, stair posts, etc.) is strong, rigid and has an even surface.
Note: If using gate on stairs, it must be placed either on the top step or on
the lowest step at the bottom.
Select the appropriate fixing method from the following list. This barrier must only
be fixed to a solid and secure surface. To install you will need a Phillips screwdriver,
pencil and drill. If unsure, check with a qualified builder or tradesperson that the
installation you intend is suitable and safe within the chosen location.
Timber Fixing
Drill 2mm (1/16’’) pilot holes and use the timber screws provided
screwing directly into the timber.
Hard Wall Fixing (Concrete or Brick)
Drill 5mm (1/5’’)pilot holes, insert wall plugs and
secure with screws.
Plaster Board Walls
Locate timber stud and follow timber fixing instructions. Plaster
board walls without studs require expandable wall plugs (not
supplied), these are available at all DIY retailers.
4