For The ON-THE-GO Pet™ INSTRUCTION MANUAL AT3 GENERATION 2 all-teRrain PET STROLLER PG8350 AT Interior Dimensions: 30.5L x 14W x 24H To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.
PARTS LIST Check that you have all the parts shown BEFORE assembling your product. If any parts are missing, call Customer Service. Front Wheel Stroller Axle 2-Rear Wheels INSTRUCTIONS FOR USE Spread the canopy apart to the open position. Back View of Stroller Canopy A. Step Here Apply brake lever by pushing down with toe. Ensure brakes are applied when parking stroller. Release by lifting brake lever with toe. Ensure the canopy is closed before folding the stroller.
UNFOLDING THE STROLLER Step 1. Release folding latch (B). C. tep 2. Spread handle (C) and seat S apart until the frame clicks and locks on both sides. Step 3. Ensure that the stroller is locked in on both sides before using. B. FOLDING THE STROLLER Step 1. Before folding the stroller, unzip stroller, and open the canopy. E. Step 2.
ASSEMBLY INSTRUCTIONS Step 1. Push back wheels on to axle, as shown in Figure F, until they lock into place. Step 2. Pull on wheel to make sure the wheel is engaged. Repeat on other side. When finished it should look like Figure G. G. F. Shown with both back wheels in place. Back Wheels Inside Outside H. To remove wheel, push the lock/release button (Figure H) and pull wheel off.
ASSEMBLY INSTRUCTIONS Step 3. To attach front wheel, slide plastic wheel support up and into tubing. Step 4. Slide wheel up, until velco pins pop out of holes. Velco Pin Tubing Velco Pin Tubing Step 5. To use stroller in locked position for jogging, push pin in. Locked Position Step 6. To use stroller in swivel position, pull pin down, and to the right.
LOOKING AFTER YOUR STROLLER • Always store product in a clean, dry place. • Not recommended for use on the beach. • Do not put heavy items on top of the stroller. • Clean frame by wiping with a lightly oiled cloth. • Do not use detergent or abrasives. Spot clean fabric with dry cleaning fluid or mild soap and warm water. • To ensure easy maneuverability and to minimize wear and tear, (especially wheels, axles, and swivels), keep all moving parts clean and lubricated with WD40® or light machine oil.
WARNING! FOR PETS ONLY. Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame. Failure to follow these warnings and the instructions could result in serious injury or death.
