Operation Manual

78
Driving
To engage reverse, the vehicle must be
stationary with your foot on the brake pedal.
F Select position R.
Reverse
There is an audible signal on engaging reverse.
The vehicle can be stopped whatever the
position of the gear selector (N, E or R).
However, there is an audible signal on opening
the driver's door if the gear selector is not at
position N.
Switching off
When the vehicle is stopped with the
engine running, always put the gear
selector to neutral N.
There is a continuous audible signal
if you turn the ignition switch to "OFF"
with the vehicle in 2
nd
, 3
rd
, 4
th
or 5
th
gear.
In this case return the ignition switch
to "ON", move the gear selector to
position N, then to position E, M or R,
then turn the ignition switch to "OFF".
On a slope, use the brakes to
immobilise the vehicle and place the
gear selector in position N, E or R.
With the ignition on, illumination
of this warning lamp indicates a
gearbox fault.
Contact a PEUGEOT dealer or a
qualified workshop.
If N is flashing in the instrument panel
accompanied by an audible signal for
a long time:
Operating faults
In all cases, it is essential that you
apply the parking brake to immobilise
the vehicle.
Before doing anything under the
bonnet, check that the gear selector is
in neutral N and the parking brake is
applied.
Limits of operation
On a gradient, or when hill start assist is
activated, never hold the vehicle using the
accelerator: you could damage the clutch.
In these situations there is an audible signal.
F Move the gear selector to position N.
F Wait 15 minutes to allow the clutch to cool
down before setting off.
- check that the ignition switch is at
the "ON" position,
- place the gear selector at N, then move it
to E, M or R.
If 1 is flashing in the instrument panel:
- place the gear selector at E or M, then
move it to N.
If R is flashing in the instrument panel:
- place the gear selector at R, then move it
to N.