User Manual

ENGLISH

FAUCET FUNCTIONS

Thank you for purchasing this Price Pﬁ ster product. All Price Pﬁ ster products are carefully engineered, and factory tested to

provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow

illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pﬁ ster

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

NOTE: If installation surface depth is thicker than 1

”, order spare part

number 971-026.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• Plumber's putty • PTFE Plumber's Tape • Slotted screwdriver

• Adjustable wrench • Pliers • Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Spout B Handles (2x) C Spout Base

D Valve Bodies (2x) E Pop-Up Assembly F Pop-Up Rod

G Seal Rings (2x) H Hose I Nut

J Bag [Nuts (2x), Square Washer (2x)] K Seal Ring

L Mounting Washer M Bag [Ball Rod, Strap]

If any of these items are missing, please contact Price Pﬁ ster Consumer Service at

1-800-Pfaucet (1-800-732-8238).

5 SPOUT ATTACHMENT

Insert Lift Rod (5A) into hole at the top of Spout (5B). Place Plastic Seal Ring (5C)

against the bottom of Spout Base (5D). Place Spout Base (5D) against the bottom of

Spout Body (5E). With Spout (5F) facing forward, carefully install the Lift Rod (5A) and

Shank (5G) through the center hole of sink (5H).

6 SPOUT INSTALLATION

From underneath sink, place Mounting Washer (6A) onto Spout Shank (6B) and align

Lift Rod (6D) with slot in Mounting Washer (6A). Make sure that the bumps on Metal

Washer (6B) are facing up. Be sure Spout (6E) is centered and facing forward and ﬁ rmly

hand tighten the Mounting Nut (6C). Secure Nut (6C) not to exceed a

turn.

Caution: Do not over tighten!