Installation Guide

ENGLISH

FAUCET INSTALLATION

Thank you for purchasing this Pster product. All Pster products

are carefully engineered, and factory tested to provide long

trouble-free use under normal conditions. This product is easy

to install using basic tools and our easy to follow illustrated

instructions. If you have any questions regarding this product,

call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Pster

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

NOTE: If installation surface depth is thicker than 1

”, order spare part

number 971-086.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE Plumber's Tape • Plumber's putty • Slotted screwdriver

• Adjustable wrench • Pliers • Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional

tools.

4 VALVE BODY PREPARATION

First, remove Clip (4A) then remove Inlet Connector (4B) from Valve Bodies (4C) and

save. Next, remove Locknut (4D), and Square Washer (4E) from Valve Bodies (4C)

and save.

5 VALVE BODY ATTACHMENT

From above sink, insert Valve Bodies (5A) through Mounting Holes (5B). The HOT valve,

with Red Ring (5C), should be positioned to the left side of the spout.

6 SECURING VALVE BODY

Before proceeding, Valve Stems (6A) are to be set in the closed position. From

underneath sink, place Square Washer (6B) onto Valve Shank (6C) and tighten loosely

with Mounting Nut (6D). Temporarily place Handle (6E) onto Valve Stem (6A) to make

sure the handle levers are properly aligned to sink. Remove Handle (6E) and tighten

Mounting Nut (6D) until Valve Body (6F) is rmly secured to sink.

Do not use handles (6E) to tighten or to rotate Valve Bodies (6F)!