Installation Guide

ENGLISH

7 9

7 HANDLE FLANGE ATTACHMENT

Place Plastic Ring (7A) and Flange (7B) over Valve Body (7C) covering the Valve Body

Washers (7D). Secure by threading Plastic Nut (7E) onto the Valve Body (7C).

8 HANDLE INSTALLATION

Screw Stem Extender (8A) onto the Valve Stem (8B). With Valves in “Closed” position,

attach Handle (8C) onto Valve Stems (8B) and tighten Set Screws (8D) with the Hex

Wrench (8E) that is provided.

Make sure Set Screw (8D) is securely tightened to Handle

(8C)

9 SPOUT BODY ATTACHMENT

Insert Lift Rod (9A) into hole at the back of Spout (9B). Place Plastic Seal Ring (9C)

against the bottom of Spout Base (9D). Place Spout Base (9D) against the bottom of

Spout Body (9E). With Spout (9F) facing forward, carefully install the Lift Rod (9A) and

Shank (9G) through the center hole of sink (9H).

10 SECURING SPOUT BODY

From underneath sink, secure Spout Body (10A) by placing Metal Washer (10B) and

threading Mounting Nut (10C) onto Spout Shank (10D). Make sure that the bumps on

Metal Washer (10B) are facing up. Make sure Lift Rod (10E) moves freely. Be sure

Spout Body (10A) is centered and facing forward and tighten the Mounting Nut (10C)

until Spout Body (10A) is rmly secured to sink.

Caution: Do not over tighten!

10A

10E

10C

10B

10D