Manual with Timer 2016

14
4. Reinstall burner and light as normal and inspect flame. If
burner requires additional adjustment repeat above procedure.
There is not a significant degree of adjustment required to these
burners.
Differences in altitude, operating conditions, weather conditions;
gas pressures, odorants and stabilizers used in both natural gas
and propane will often cause burners to burn differently. As
long as you are getting good ignition, even cooking performance
and the burner flame is blue with yellow tips and operating
consistently, you should not have to adjust the burners.
YELLOW TIPPING
Properly adjusted burner
NORMAL HARD FLAMES
Slightly out of adjustment burner
YELLOW FLAMES
Extremely out of adjustment burner
GRILL COVER
WE STRONGLY RECOMMEND COVERING YOUR PGS GAS GRILL WHEN
NOT IN USE. YOU MAY PURCHASE A COVERED DESIGNED TO FIT
YOUR GRILL FROM YOUR PGS DEALER. ASK ABOUT OUR COVER
THAT MAY BE PLACED ON YOUR GRILL JUST ONE MINUTE AFTER
TURNING GRILL OFF… WHILE IT IS STILL WARM… A PGS EXCLUSIVE!
REPLACEMENT PARTS
USE ONLY PGS ORIGINAL REPLACEMENT PARTS AVAILABLE THROUGH
YOUR DEALER OR CONTACT AEI CORPORATION FOR CLOSEST PARTS
SUPPLIER.
BURNER, AND MAY POSE A SAFETY RISK.
TIMER TROUBLESHOOTING
PGS uses the finest mechanical timer available to control the
gas flow to grill head. Operating instructions are found on the
following page and if followed should provide safe and long
lasting use of timer.
The timer knob should turn freely, if it impinges on the control
panel it will stop and will not operate.
We recommend pulling timer knob off at least once a month
and cleaning assembly with compressed air to remove any and
all debris.
It is possible to break the knob if turned in the wrong direction.
Replacement knobs are available from AEI Corporation.
If timer fails to operate, we offer replacement timer with knob
which will require entire control panel, manifold, valve and
timer assembly to be removed and taken apart.
We also offer a replacement control panel, manifold, valve and
timer assembly.
PART NUMBERS FOR REPLACEMENT PARTS ARE FOUND BELOW:
PART #: DESCRIPTION:
WA KNOB 15 TIMER KNOB (ALL MODELS)
WA 312 REPLACEMENT TIMER WITH KNOB
MTA27N T27NG CONTROL PANEL/MANIFOLD/VALVE/TIMER
ASSB
MTA27L T27LP CONTROL PANEL/MANIFOLD/VALVE/TIMER
ASSB
MTA36N T36NG CONTROL PANEL/MANIFOLD/VALVE/TIMER
ASSB
MTA36L T36LP CONTROL PANEL/MANIFOLD/VALVE/TIMER
ASSB