Manual with Timer 2016

6
IT IS YOUR RESPONSIBILITY TO:
ASSEMBLE, INSTALL, LEAK CHECK, CARE AND OPERATE
YOUR GAS GRILL. SAVE INSTRUCTIONS FOR FUTURE
REFERENCE.
FOR YOUR SAFETY IF YOU SMELL GAS:
1. SHUT OFF GAS TO THE APPLIANCE.
2. EXTINGUISH ANY OPEN FLAME.
3. OPEN LID.
4. IF ODOR CONTINUES, IMMEDIATELY CALL YOUR GAS
SUPPLIER.
THIS GAS GRILL IS DESIGNED FOR OUTDOOR USE ONLY
FOR YOUR SAFETY
KEEP AREA CLEAR FROM ANY COMBUSTIBLES. DO NOT
STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS APPLIANCE.
THIS GRILL IS NOT INTENDED FOR USE ON A BOAT OR
RECREATIONAL VEHICLE.
STORE THE LP GAS (PROPANE) CYLINDER OUTDOORS IN A
WELL-VENTILATED SPACE. DO NOT STORE A PROPANE
GAS CYLINDER IN DIRECT SUNLIGHT. DO NOT STORE
EXTRA CYLINDERS IN CART OR NEAR GRILL. DO NOT
STORE PROPANE CYLINDER ON SIDE.
Teflon tape or pipe joint compound will be required
on all steel pipe connections. Never use a sealer
when your connection is brass to brass. Brass to
brass is self-sealing.
The grill itself is partially assembled, with the burner,
venturi, ignitor, collector box, and ignitor lead wire installed. Take
your time in assembly. Please read instructions thoroughly before
starting assembly.
This manual is based on information available when the manual was
printed. Continued improvements in design could cause changes in
the grill that may or may not be included herein.
Please consult your authorized PGS dealer if you have any questions
concerning assembly, installation or operation of your grill.
PLEASE RETAIN INSTRUCTIONS FOR FUTURE REFERENCE, TAKE
THE TIME NOW TO RECORD THE MODEL AND SERIAL NUMBERS
HERE. PLEASE RETURN OWNER REGISTRATION CARD
IMMEDIATELY. RETURN OF WARRANTY CARD INSURES WARRANTY
REGISTRATION.
MODEL IDENTIFICATION
A model number identifies your PGS Grill and a serial number located
on the stainless steel grease tray that is included in your grill head.
Always use both the model number and the serial number when
calling or writing AEI CORPORATION about your grill.
UPON UNBOXING YOUR GRILL, PLEASE NOTE THE
FOLLOWING:
MODEL NUMBER _______________________
TYPE OF GAS _______ NAT GAS______ PROPANE
SERIAL NUMBER _____________________________
DATE PURCHASED____________________________
DEALER NAME_______________________________
CITY, STATE_________________________________
PLEASE RETURN REGISTRATION CARD TODAY
SAFETY
YOUR GRILL IS DESIGNED FOR OUTDOOR USE ONLY. Please
thoroughly review all safety statements recapped on pages four and
five on this manual and found throughout.
The grill must be located no closer than 30"
from any combustible material below, behind
or to the sides. The grill should not be located
under overhead combustible materials.
Keep the area around the grill clear of combustible
materials, flammable vapors or liquids such as
gasoline. The grill surfaces become very hot during use. Keep
children and pets away. Use hot pads or oven mitts.
GAS
Both natural gas (NG) and propane gas (LP) have a long history of
safe use, when simple rules are followed. If not, there is danger of
fire or explosion.
Check Local Codes. Consult your local LP dealer or Natural Gas
Company listed in your local directory for recommended installation
procedures and regulations. In the absence of local codes,
installation must conform to the National Fuel Gas Code, ANSI
Z233.1.
NEVER USE NATURAL GAS IN A UNIT
DESIGNED FOR LIQUID PROPANE OR
THE REVERSE. IF YOU WISH TO CONVERT
YOUR GRILL FROM ONE TYPE OF GAS TO
THE OTHER, PLEASE CONTACT YOUR LOCAL
DEALER, DISTRIBUTOR, OR AEI CORP.
Never connect an unregulated propane gas cylinder or unregulated
natural gas to your gas grill (Note: most homes equipped with
natural gas have a regulator near the gas meter).
SAFETY INFORMATION OF PROPANE MODELS
Your PGS grill is designed to operate on propane gas regulated at a
gas pressure of 11" water column (W.C.) (2.7kPa). If you are
hooking your grill into “System LP” which fuels your home, please be
certain that you are at this pressure.
Operating your grill at pressure higher
or lower than recommended may damage
the grill or result in a hazard or poor
performance.
A regulator adjusted to this pressure must be installed in the gas
supply line before the grill is connected to the propane source. PGS
propane gas grills include a 11” W.C. regulator and a “TYPE I
“ Cylinder Connection Device. This system complies with the
specifications and requirements of ANSI Z21.58b standards. This
system can only be used with a QCC Type I tank. Our hoses include
an excess flow safety system that will stop the flow of gas to your grill
in the event of leaking gas or a damaged hose.
PLEASE NOTE THIS SYMBOL
IT DEALS WITH PRODUCT
SAFETY ISSUES AND
WARNINGS