Operation Manual

ADSL2/2+ Modem Router
www.phicomm.com
22
Chapter 4: Software Configuration
3. PPPoA/PPPoE
Select this option if you have a username and password to access internet. This option is
typically used for DSL services. Select Dynamic to obtain an IP address automatically for your
PPP connection. Select Static to use a static IP address for your PPP connection. Please enter the
information accordingly.
Service name: This is optional, if you don’t have a service name, leave it blank.
Username: Enter your username for your PPPoA/PPPoE connection.
Password: Enter your password for your PPPoA/PPPoE connection.
Encapsulation: For both PPPoA/PPPoE connection, you need to specify the type of Multiplexing,
either LLC or VC -Mux.
Bridge Interface: Activate the option, the Router can also work in Bridge mode.
Connection: For PPPoA/PPPoE connection, you can select Always on, Connect on-Demand or
Connect Manually. Connect on demand is dependent on the traffic. If there is no traffic (or Idle)
for a pre-specified period of time, the connection will tear down automatically. And once there is
traffic sending or receiving, the connection will be automatically on.
TCP MSS Option: Enter the TCP MSS as you desire.
Get IP Address: For PPPoA/PPPoE connection, you need to specify the public IP address for this
Modem Router. The IP address can be either dynamically (via DHCP) or given IP address