Operation Manual

ADSL2/2+ Modem Router
www.phicomm.com
25
Chapter 4: Software Configuration
LAN
Router Local IP: These are the IP settings of the LAN interface for the device. These settings may
be referred to as private settings. You may change the LAN IP address if necessary. The LAN IP
address is private to your internal network and cannot be seen on the Internet.
IP Address: Modem Router’s local IP Address, you can access to the Web based Setup Wizard via
the IP Address, the default value is 192.168.1.1.
IP Subnet Mask: Enter the Subnet Mask, the default value is 255.255.255.0.
Dynamic Route: Select this option to specify the RIP (Routing Information protocol) version for
LAN interface, including RIP1, RIP2-B and RIP2-M. RIP2-B and RIP2-M are both sent in RIP2 format,
the difference is that RIP2-M using Multicast, while RIP2-B using Broadcast format.
Multicast: Select IGMP version, or disable the function. IGMP (Internet Group Multicast Protocol)
is a session-layer protocol used to establish membership in a multicast group. The ADSL ATU-R
supports both IGMP v1 and IGMP v2. Select Disabled to disable this function.
IGMP Snoop: Activate the IGMP Snoop function if you need.
DHCP: Select Enabled, then you will see the screen below.
The Modem Router will work as a DHCP server, it becomes the default gateway for DHCP clients
connected to it. DHCP stands for Dynamic Host Control Protocol. The DHCP Server gives out IP
addresses when a device is booting up and request an IP address to be logged on to the
network. That device must be set as a DHCP client to obtain the IP address automatically.
By default, the DHCP Server is enabled. The DHCP address pool contains the range of the IP
address that will automatically be assigned to the network clients.