Operation Manual

ADSL2/2+ Modem Router

www.phicomm.com

Chapter 2: Hardware Installation

Physical Connection

Before installing the device, please make sure your broadband service provided by your ISP is

available. If there is any problem, please contact your ISP. You need to connect the device to the

phone jack, the power outlet, and your computer or network. Before cable connection, turn off

the power supply and keep your hands dry. You can follow the steps below to install it.

Step 1: Connect the ADSL Line.

Method one: Plug one end of the twisted-pair ADSL line into the DSL port on the rear panel of

FD-222, and insert the other end into the wall socket.

Method two: You can use a separate splitter. External splitter can divide data and voice, and then

you can access the Internet and make calls at the same time. The external splitter has three

ports:

• LINE: Connect to the wall jack.

• PHONE: Connect to the phone sets.

• MODEM: Connect to the DSL port of FD-222. Plug one end of the twisted-pair ADSL line into

the DSL port on the rear panel of FD-222. Connect the other end to the Modem port of the

external splitter.

Step 2: Connect the Ethernet cable. Attach one end of a network cable to your computer’s

Ethernet port or a regular hub/switch port, and the other end to the LAN port on FD-222.

Step 3: Attach the power adapter. Connect the AC power adapter to the PWR connector on the

rear of the device and plug in the adapter to a wall outlet or power extension.

Step 4: Turn on FD-222 and power on the computers and LAN devices.

Note:

 If you currently use a modem, disconnect it, the Modem Router will replace your old

modem.