Operation Manual
50
ENGLISH
Machine actions Causes Solutions
The machine grinds the
co ee beans but no co ee is
brewed (see note)*.
The brew group is dirty. Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as
described in the “Saeco Adapting
System” chapter.
The co ee dispensing spout is
dirty.
Clean the co ee dispensing spout.
The co ee is too weak (see
note)*.
This might occur when the ma-
chine is automatically adjusting
the dose.
Brew a few cups of co ee as
described in the “Saeco Adapting
System” chapter.
The ceramic co ee grinder is set
to a coarse grind.
Adjust the ceramic co ee grinder
to a ner setting (see the “Adjust-
ing the Ceramic Co ee Grinder”
chapter).
Co ee is brewed slowly (see
note)*.
The co ee grind is too ne. Change co ee blend or adjust the
grind as explained in the “Adjusting
the Co ee Grinder” chapter.
The brew group is dirty. Clean the brew group (see the
"Weekly Cleaning of the Brew
Group" chapter).
Co ee leaks out of the co ee
dispensing spout.
The co ee dispensing spout is
clogged.
Clean the co ee dispensing spout
and its holes.
No hot water or steam is
dispensed.
The hole of the steam/hot water
wand is clogged.
Clean the hole of the steam wand
using a pin.
Make sure that the machine is
o and has cooled down before
performing this operation.
The descaling cycle cannot
be nished.
Most probably you have used not
enough water for rinsing.
Unplug the power cord and follow
the instructions described in the
chapter “ Interruption of the descal-
ing cycle”.
Note:
(*) These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case, wait until
the machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.