Quick Start Setup Guide 46HFL3683S 40HFL3683S 32HFL3663S
Know these safety symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This “bolt of lightning” indicates un-insulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering.
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. 2. 3. 4. 5. 6. 7. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. P&F USA reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. The material in this manual is believed adequate for the intended use of the system.
Environmental care The packaging of this product is intended to be recycled. Contact your local authorities for information about how to recycle the packaging. For product recycling information, please visit - www.recycle.philips.com End of life directives This LCD TV contains a lamp with Mercury, please dispose of according to all local, state and federal laws. Philips pays a lot of attention to produce environmentally friendly products. Your new TV contains materials which can be recycled and reused.
Positioning the TV Warning • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Large screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Before you move the TV, disconnect attached cables to prevent damage to connectors. • Ensure that you always have easy access to the AC power cord or plug to disconnect the TV from the power.
5 Channel installation This section describes how to install the TV channels automatically. 1 2 Connect the RF signal to the TV. Plug the power cord into the power outlet. 46HFL3683S / 40HFL3683S Select [Consumer TV setup] - [Setup] - [Autoprogram]; then select Cable. (unless the installation is using only Antenna signals - in which case you would select Antenna) Note • The TV will not tune any channel that has not been first “installed”. This includes SPI direct tune commands! ANT.
46HFL3683S / 40HFL3683S a g DATA h b c d i j e f a DATA (RJ-12 SPI port) f HDMI 1 / HDMI 2 input jack b Component video and audio input jack g USB terminal c Composite video and audio input jack h Audio input jack for HDMI 3 and PC d Digital audio output jack i PC input jack e Antenna input jack j HDMI 3 input jack 32HFL3663S g a b h i 1 c DATA j 3 k d e f a S-Video input jack f DATA (RJ-12 SPI port) b Composite video and audio input jack g Analog audio output jack c HDMI 2 inp
Configure the Switch on settings Configure the Control settings 1 2 1 2 Press MENU and select [Switch on settings]. Press Î or ï to select the desired mode, then press OK. • [Switch on volume]: Defines the pre-set volume level when TV is powered on. • [Maximum volume]: Defines the maximum limit of volume level. • [Switch on channel]: Defines the power-on channel number or external video input. • [Power on]: Determines the state of the TV when the AC power is provided or restored.
Changing picture and sound settings Clone TV configuration data You must set [Home] in [Location]. Otherwise, these settings will not be memorized after the unit goes to standby mode. Once you have completed the setup of the master TV and tested that it receives all the required channels, follow the TV to USB section below to extract a copy of the setup configuration to a USB storage device. Changing picture settings 1 2 3 4 Press MENU; navigate to [Consumer TV setup] [Picture].
EN 11
P&F USA, Inc. PO Box 430 Daleville, IN 47334-0430 P&F Mexicana, S.A. de C.V. Av. La Palma No. 6, Col. San Fernando La Herradura, Huixquilucan Edo. de México C.P. 52787 TELEVISOR A COLOR DE CRISTAL LIQUIDO (LCD) MODELO LCD IMAGEN VISIBLE ENERGIA 46HFL3683S/F7 46”(116,84cm) 116,81cm 120V ~ 60Hz 217W Comercializado por : P&F MEXICANA, S.A. de C.V. IMPORTADOR : P&F MEXICANA, S.A. de C.V. La Palma No. 6, Col. San Fernando La Herradura Huixquilucan, Edo. México.
