Quick Start Manual

7EN

Channel installation

This section describes how to install the TV channels

automatically.

1 Connect the RF signal to the TV.

2 Plug the power cord into the power outlet.

46HFL3683S / 40HFL3683S

Cable

ANT. IN

32HFL3663S

Cable

3 Turn the TV on.

• Press

POWER at the side of the TV or use the

(POWER) on the remote control.

46HFL3683S / 40HFL3683S

32HFL3663S

4 Press RC5 SETUP to put the remote control into setup

mode, then press the HOME/MENU button to display

the setup menu. (Hereafter, HOME/MENU will be simply

referred to as MENU)

5 Select [Consumer TV setup] - [Setup] - [Autoprogram];

then select Cable. (unless the installation is using only

Antenna signals - in which case you would select

Antenna)

Note

• The TV will not tune any channel that has not been ﬁ rst “installed”. This

includes SPI direct tune commands!