Service manual

3. Remove/lift the 'LSP top bracket' after removing the 2 screws that hold the
bracket at the right side.
4. Remove the shielding of the SSB, and release the coax cable (the one going to
connector 0946 on LSP) from the metal groove. In this way this coax cable is
long enough to connect to the LSP (see figure below).
5. Organize/reorganize the cabling when you put the SSB on the extension panel.
The only cable not necessarily needed is the longest coax cable. You do not
have DW/PIP functionality then, but in that case you can localize the fault to the
DW module. (If necessary, you can order a longer coax cable under number
3104 311 00351).
6. Both sides of the SSB are now accessible for servicing.
Figure: