Service manual
Table Of Contents
Mains Switch Panel Removal
Figure:
The easiest way to access this module is with the LSP in service position 2.
1. Position the cabinet a bit over the edge of a table, and push the release catches
up from the bottom side of the set [1].
2. At the same time pull the Mains Panel assembly backward and remove it [2].
Rear Cover Mounting
Before you mount the Rear Cover, perform the following checks:
• Confirm that the AC Power Cord is mounted correctly in its guiding brackets.
• Confirm that all cables are replaced in their original positions. This is very
important due to the large 'hot' area of the set.