Service manual

How to enter
Use one of the following methods:
• Via a standard RC transmitter: key in the code '062596' directly followed by the
'MENU/SELECT' button.
• Via ComPair (simulating the DST).
• Via grounding the 'Front Detect' line (pins 1 and 7 of connector 0240) on the Side
I/O panel while disconnecting and reconnecting the AC power cord.
CAUTION: Entering SDM by grounding the 'Front Detect' line will override the 5V
protection. This should only be done for a short period. In case of SW protections
(errors 1 - 4 and 8), the set will shut down in 15s.
When doing this, the service technician must know what he is doing as it could lead to
damaging the set.
After entering SDM, the following screen will be shown with 'SDM' at the upper right
side for recognition.
Figure: SDM Menu