User manual

Using Manual Converge: Multipoint Red/Blue

The Multipoint Red/Blue convergence controls allow you to adjust

picture convergence at specific points on the TV screen.

Note: Allow the TV to warm up for 20 minutes before adjusting

convergence. Adjust Converge Red or Converge Blue before using the

Multipoint Red/Blue controls. See the previous page.

Select MULTIPOINT RED or MULTIPOINT BLUE in the

MANUAL CONVERGE menu.

Press the cursor right to enter navigate mode.

Use the cursor left, right, up or down to move to a cross hair

that has a colour outline.

Press the OSD (Status/Exit) key to enter adjust mode.

Use the cursor left, right, up or down to adjust the cross hair

until the colour outline is gone.

Press the OSD key to return to navigate mode.

Repeat steps 3-6 until all misaligned cross hairs have been

adjusted. Then press the MENU key.

For your multipoint adjustments to be stored in the TV’s

memory, you must activate SAVE MULTIPOINT.

Note: If you are not satisfied with the adjustments you just made

and want to start over, you can use the UNDO MULTIPOINT

control. This control allows you to undo the adjustments, but only

if you use it before saving.

To save your multipoint adjustments: Select SAVE MULTIPOINT

and press the cursor left or right.

To undo your multipoint adjustments: Select

UNDO

MULTIPOINT and press the cursor left or right.

To restore the TV’s picture convergence to factory settings, select

RESTORE FACTORY and press the cursor left or right.

Press the MENU key to return or the OSD key to switch the

menu off.