4608/07/05/ 04/03/02/01X Rechargeable Cordless Razor
IMPORTANT SAFETY INSTRUCTIONS When using an electric razor, basic precautions should always be followed,including the following: Read all instructions before using this appliance. DANGER To reduce the risk of electric shock: 1. Do not reach for a razor that has fallen into water. Unplug immediately. 2. Do not use while bathing or in a shower. 3. Do not place or store razor where it can fall or be pulled into a tub or sink.Do not place or drop into water or other liquid. 4.
TABLE OF CONTENTS FEATURES 2-3 INDICATIONS 4 CHARGING 4 PUT IT TO THE TEST & SHAVING TIPS 5 HOW TO SHAVE WITH AN ELECTRIC RAZOR 5 TRIMMING 6 CLEANING 6-9 ASSISTANCE 10 ACCESSORIES 10 BATTERY REMOVAL 10 WARRANTY Back Cover 60 - DAY MONEY- B ACK GUA R A N T E E To enjoy the closest and most comfo rtable shave from your new Norelco Men’s R a z o r, the razor should be used e x c l u s i ve ly for 3 we e k s .
2. 3.
4. 5. INDICATIONS Charging or recharging at temperatures below 40ºF or higher than 95ºF adversely affects lifetime of batteries. PUT IT TO THE TEST & SHAVING TIPS 21 Day Trial and Conversion process. It is a fact that your skin and beard need time to adjust to a new shaving system. Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Norelco shave.* At first you may not get as close a shave as you expect, or your face may even become slightly irritated.
. 7. TRIMMING To groom sideburns and moustache: 4 Brush the inside of housing and Razor Head Assembly. 1 Turn razor ON by locking the switch to the “ON” position. 5 Replace the Razor Head Assembly back on razor. 2 Push up Trimmer Slide Switch. 3 Hold Trimmer as shown and move in downward strokes with gentle pressure. 4 Close Trimmer by sliding Trimmer switch down. 5 Turn razor OFF by locking switch to the “OFF” position.
8. 9. 7 Remove and clean one cutter and head at a time. • Be careful not to mix up cutters and heads. They are a matched set and if interchanged,it will greatly affect shaving performance. 14 Press down and turn the wheel clockwise until it locks into place. 8 Separate the cutter from the comb. 15 Replace the Razor Head Assembly back on razor. 9 Only brush the cutter in an upward motion. Use the short bristled side of the brush. 10 Brush the slots of the razor head.
10. ASSISTANCE For assistance or the Authorized Norelco Service Location nearest you,call toll free: 1-800-243-3050 or visit our website:www.norelco.com Authorized Norelco Service Location information is available 24 hours a day, 7 days a week. ACCESSORIES Replacement Heads • Model HQ4 - For maximum razor performance, replace your Norelco Micro Action razor heads once a year.