User Manual

4 Use your TV
Switching on your TV and putting it in Standby
mode
Remote Control
TV
* Key on Rear
To Turn the TV On from Standby or Off to Standby
●
Press B on the Rear panel or the Remote Control.
Note(s)
●
Energy Consumption contributes to air and water pollution. When the AC Power Cord
is plugged in, your TV consumes energy with a very low standby Power Consumption.
Adjusting Volume
Remote Control
TV
* Key on Rear
To decrease or increase Volume
●
Press VOL J / K on the Rear panel or press VOL + / – on the Remote
Control.
VOL J (–) : Volume Down
VOL K (+) : Volume Up
To mute or unmute sound
●
Press V on the Remote Control to mute the sound.
●
Press V again or VOL + / – to recover the original sound.
Switching Channels
Remote Control
TV
* Key on Rear
To select Channels by using CH H / I or CH + / –
●
Press CH H (Up) / I （Down) on the Rear panel or press CH + / –
on the Remote Control.
To select Channels by using the NUMBER buttons
Digital TV Operation
●
For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
–
When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
–
When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use the NUMBER buttons.
●
Channel not available or No Signal will appear on the TV screen after the subchannel
broadcast is over.
●
Audio Only message will appear on the TV screen, when you receive only sound signal.
* All CONTROL Keys are located on the Rear (lower right) side of the
unit as viewed from the Front.
20
.English