Quick start guide

6
S
ETTING
TIME MANUALLY
1
Follow steps 1–3 in the section “Setting Time
Automatically” above, then press the CURSOR RING
DOWN to highlight MANUAL and CURSOR RING
RIGHT to enter the MANUAL time input area.
2
Use the number buttons on your remote control to input
the first digit for the time. You can also press the CURSOR
RING UP or DOWN to select a digit. Press the CURSOR
RING RIGHT to move to the next digit input slot and input
the time.
If you should need to change a number you have input, you
can cursor left or right to the digit input slot to make the
correction.
3
After you have input the time, press the CURSOR
RING RIGHT to enter the AM/PM area. Then press the
CURSOR RING UP or DOWN to select AM or PM.
4
Press the STATUS/EXIT button to exit the menu.
PIP
213
546
879
0
TV
SWAP PIP CH
DN
UP
FREEZE
SOUND
MUTE
SURF
A/CH
POWER
PICTURE
STATUS/
EXIT
POSITION
VCR
ACC
MENU/
SELECT
VOL
CH
TV/VCR
ACTIVE
CONTROL
SET TIME
AUTO
MANUAL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
AutoChron
INSTALL
11:00 AM
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
AutoChron
INSTALL
1
3
4
2
ENTER TIME
PIP ON/OFF
546
879
0
SURF
A/CH
SURF
ITR/
RECORD
HOME
VIDEO
HOME
MOVIES
PERSONAL
SLEEP
REC •
PIPPOSITION
TV/VCR
FORMAT
SAP
PROG.LISTDOLBY VAV
RING RIGHT. Within a few seconds, the option of
Daylight Savings Time appears on screen.
6
If the Daylight Savings Time option you want to select
is not highlighted, press the CURSOR RING UP or
DOWN to highlight the option. Then press the CURSOR
RING RIGHT to activate your selection.
7
Press the number buttons on your remote to enter the
channel number for your PBS station (02, 15, or 121, for
example). Wait until the TV completes its search. If the
time was not found, you will need to locate the correct
channel number for your PBS station and input that num-
ber.
8
Press the STATUS/EXIT button to exit the menu.
PBS station.You will need
to input the correct num-
ber for the time to be
found.