User Manual

PhotoFrame Firmware Upgrade Instructions
Applicable models 7FF2FPA
Firmware version 1.0.14
Release date December 12, 2008
Release notes
!
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1 Format SD (Secure Digital) card
2 Copy all files from the ‘Firmware’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3 Make sure PhotoFrame is powered Off
4 Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5 Push the Power button to power on the PhotoFrame
6 The firmware upgrade will start automatically
!
Warning: Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
!
7 When "System will reboot after replugging out of the memory card" shows, firmware
upgrade has finished
8 Remove the memory card from the PhotoFrame, PhotoFrame will reboot.
9 The upgrade has completed
You can check the new firmware version via Setup → Status →Firmware.