Quick start guide

Display

Pluto Non DI_HK

90x127mm

3000 060 99131

The lter may produce smell after being used for a while because of the absorption of indoor

air. Remove the lter and place it where it has direct sunlight and ventilation for several

hours. Re-install and try using it again. If the odor remains, please replace the lter.

Control

Very poor

Mode switch/

Filter reset

Replace the NanoProtect Filter Series 2

(AC0819/AC0820: FY0194, AC0830: FY0293).

Long press the for 3 seconds.

Clean the surface of the lter

every 4 weeks.

Clean the surface of the lter

Power on/o

Maintenance

Good PoorFair

Air quality light

Filter replacement alert

Air quality

Auto Turbo Sleep

顯示

開始使用後的濾網因吸收了室內空氣，可能會產生少許異味。取出過濾網並放置在

陽光直射和通風的地方數小時。重新安裝過濾網，再次嘗試使用。如果仍有異味，

請更換過濾網。

控制

非常差

模式切換/

濾網重設

每 4 週清潔濾網表面

清潔濾網表面顯示時，更換濾網

電源開啟/關閉

更換濾網 (AC0819/AC0820: FY0194,

AC0830: FY0293) 後，長按 3 秒

維護

良好差一般

空氣質素指示燈

濾網更換提示

空氣質素水平

自動特強睡眠

Replace lter when display shows

PAGE 1
Pluto Non DI_HK Control 90x127mm 控制 Mode switch/ Filter reset Auto Turbo 模式切換/ 濾網重設 Sleep 自動 Power on/off 特強睡眠電源開啟/關閉 Display 顯示 Air quality light 空氣質素指示燈 Air quality Good 空氣質素水平 Fair Poor Very poor 良好 Filter replacement alert Clean the surface of the filter every 4 weeks. 差非常差濾網更換提示 Maintenance Clean the surface of the filter 一般維護 Replace filter when display shows Replace the NanoProtect Filter Series 2 (AC0819/AC0820: FY0194, AC0830: FY0293). Long press the for 3 seconds.