IFU_AJ100_eur_ENG Clock Radio User manual 2006.11.
IFU_AJ100_eur_ENG 2006.11.
IFU_AJ100_eur_ENG 2 3 4 2006.11.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 4 English SUPPLIED ACCESSORIES – 1 X AC 7.5V adapter (Input: 220-230V ~ 50Hz 30mA, Output: 7.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 5 SIDE PANEL (See 1) 8 TUNING +/- – tunes to radio stations 9 Pigtail – improves FM reception 0 DC 7.5V – socket for AC/DC 7.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 6 SELF-POWERED BACK-UP The self-powered back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and backlight illumination will be switched off. If power supply returns after 3 minutes and the display shows: • clock time blinking - indicates you need to re-adjust the clock time.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 7 RADIO 1 Press RADIO ON/OFF once to switch on the radio. ™ Display shows the radio frequency of the last selected waveband briefly before returning to the clock time. Your preset station is also shown if you are listening to a preset. (See 2) 2 Adjust the sound using VOLUME. 3 To select preset stations, press the respective PRESET button (1-5) once or repeatedly. 4 Press RADIO ON/OFF to switch off.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 8 USING THE ALARM GENERAL Two different alarm times can be set. This can be useful when you need to be woken up at a different time e.g. during the week and at the weekend: • ALARM - radio mode • ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds. SETTING THE ALARM TIME AND MODE (See 3) 1. Check the radio is switched off. 2. Press ALARM or ALARM to on. ™ Display: OFF disappears under the respective AL or AL icon. 3.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 9 SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24-hour ALARM RESET will be automatically selected after 59 minutes from the time your alarm first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET / SLEEP. ™ You will hear a beep tone confirming 24 hour reset activation.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 10 SLEEP (See 4) About Sleep This set has a built-in sleep timer, which enables the radio to be automatically switched off after a set period of time. There are four sleep time options. Setting and switching off SLEEP 1 Within 1 second, press ALARM RESET / SLEEP twice until the display shows SLEEP and SL: 60. ™ The radio is automatically switched on and tunes to the last station.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 11 MAINTENANCE & SAFETY • Install the unit near the AC outlet and where the AC power plug can be easily reached. • The apparatus shall not be exposed to dripping or splashing. • Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean your set, use a soft damp cloth or chamois leather. Do not use cleaning products, which contain benzene, thinner, etc. as these may harm the housing.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 12 TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 13 CAUTION - Visible and invisible laser radiation. If the cover is open, do not look at the beam. - High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any user-serviceable parts. - Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 14 Clock radio Meet Philips at the Internet http://www.philips.