Register your product and get support at EN User manual AJ7030D
A a b f c d e g h i j m k l B n
C D
E F G
1 Important Safety Important Safety Instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
k Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. l Unplug this apparatus during lightning storms or when unused for long periods of time. m Refer all servicing to qualified service personnel.
o Apparatus shall not be exposed to dripping or splashing. p Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). q This product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM radio; • enjoy audio from iPod/iPhone or an external device; • know the time; and • wake up by buzzer alarm, radio, or audio in iPod/iPhone.
c d e f g h i j k l m • • Turn on/off the clock radio. Switch the clock radio to standby mode. AL1/AL2 Set alarm. View alarm settings. Activate/deactivate alarm timer. • • • SNOOZE/BRIGHTNESS Snooze alarm. Adjust display brightness. • • iPod/iPhone • Dock for iPod/iPhone. VOLUME +/Adjust volume. • SET • • Store radio stations automatically/manually. Set clock. SLEEP Set sleep timer. • SOURCE Select source. • Battery tray AUX IN Connect an external audio device.
n 3 DC 5V Power supply socket. • Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Install battery Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Note •• You can only use AC power as power supply. The pre-installed lithium CR2032 battery can only back up time and alarm. •• When power is disconnected, the display backlight is off. For first-time use: Remove the protective tab to activate the battery. To replace the battery: B Connect power C Caution •• Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio.
Note •• If clock is not manually set, when iPod/iPhone is connected, the clock radio synchronizes time from the iPod/iPhone automatically. Turn on Press . »» The clock radio switches to the last selected source. Switch to standby mode Press 4 to switch the clock radio to standby mode. »» The clock (if set) appears on the display panel. Play from iPod/iPhone You can enjoy audio from iPod/iPhone through this clock radio.
• • iPhone 3G iPhone Listen to audio from iPod/iPhone 1 2 3 Press SOURCE repeatedly to select iPod/iPhone mode. Place the iPod/iPhone in the dock. D Start to play audio from the iPod/iPhone. Remove the iPod/iPhone E Pull the iPod/iPhone out of the dock. Charge the iPod/iPhone When the clock radio is connected to power, the docked iPod/iPhone starts charging.
5 Listen to FM radio Tune to FM radio stations Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna. 1 2 Press SOURCE repeatedly to select FM tuner source. Press and hold TUNING +/- for 2 seconds. »» The clock radio tunes to a station with strong reception automatically. 3 Repeat steps 2 to tune to more stations.
Store FM radio stations manually 1 2 3 4 5 Tune to an FM radio station. Press SET. »» The preset number begins to blink. Press PRESET / repeatedly to select a number. Press SET again to confirm. Repeat steps 1 to 4 to store other stations. Note •• To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET / 6 to select a preset number.
1 2 3 4 Press and hold AL1/AL2 for two seconds to activate alarm setting mode. »» The hour digits and alarm icon begin to blink. Press TUNING +/- or / to set the hour. Press AL1/AL2 to confirm. »» The minute digits begin to blink. Repeat steps 2 to 3 to set the minute and alarm volume. G Select alarm source Adjust AL1/2 iPhone·RADIO·BUZZ control to select alarm source for both alarms. Note •• When alarm time comes, the selected radio, buzzer, or iPod/iPhone turns on.
Snooze alarm When alarm sounds, press SNOOZE. »» The alarm snoozes and repeats ringing nine minutes later. Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP repeatedly to select the sleep timer period (in minutes). »» When the sleep timer is activated, appears. To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears.
Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness levels. 7 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 X 3 W RMS Tuner Tuning Range FM: 87.
General information AC Power Model: ASSA28-050200; Output: 5 V; 2 A Operation Power Consumption 8 W Standby Power Consumption <1 W Dimensions - Main Unit (W x H x D) 198 x 71 x 111 mm Weight - With Packing - Main Unit 0.9 kg 0.5 kg 8 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service.
No response from the clock radio •• Disconnect and reconnect the AC power plug, then turn on the clock radio again. Poor radio reception •• Increase the distance between the unit and your TV or VCR. •• Fully extend the FM antenna. Alarm does not work •• Set the clock/alarm correctly. Clock/alarm setting erased •• Power has been interrupted or the power plug has been disconnected. •• Reset the clock/alarm.
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. iPod and iPhone are trademarks of Apple Inc., registered in the U.S.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ7030D_98_UM_V2.