Service manual

2-4
CS 49 105
POWER SUPPLY
5
Open the battery compartment of the set and insert 6 batteries, type R20, UM-1 or D-cells (preferably alkaline). Remove batteries if they are flat or if the set is not going to be used for a long time.
Batteries contain chemical substances, so they should be
disposed of properly.
1 Check whether the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult your dealer or service organisation.
The type plate is located
on the bottom of the set.
2 If the set is equipped with a VOLTAGE selector A, set this
selector to the local mains voltage.
3 Connect the mains cable to the AC MAINS socket and the wall
socket. This switches on the mains supply.
The mains cable is
inside the battery compartment.
The battery supply will be switched off when the set is connected to the mains. To change over to battery supply, pull out the plug from the unit’s AC MAINSsocket. To disconnect the set from the mains completely, remove the mains plug from the wall socket. For users in the U.K.: please follow the instructions on page 2.
A
Mains Batteries (optional)
English
Environmental information All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packing materials, exhausted
batteries and old equipment.
6
English
Set the POWER slider to the desired sound source: CD, TAPE, or BAND (for radio). The set is switched off when the POWER slider is set to OOFFFF/TAPE
and the keys of the tape deck are released.
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjust the volume using the VOLUME control. Increase and decrease the bass level by pressing DBB. The bass level can also be emphasised if you place the set against wall or shelf. Do not cover any vents; leave sufficient room around the unit for ventilation. 1 Set the POWER slider to FM or MW to select the desired
wave band.
2 Tune to the desired radio station by using the TUNING wheel. Improving RADIO reception For FM stations, pull out the telescopic antenna. To improve the signal, incline and turn the antenna. Reduce its length if the signal is too strong (very close to a transmitter). For MW stations, direct the built-in antenna by turning the whole set. The telescopic antenna is not needed.
OPEN
FM AM
1700
1300
1000
800
630
100
98
97
104
108
HRO START RECORDING
Radio – tuning to radio stations
POWER
DBB
DYNAMIC
BASS
BOOST
VOLUME
CD SYNCHRO STA
R
Adjusting volume and sound
OFF
BAND
TAPE
CD
FM
AM
POWER
DBB
DYNAMIC
BASS
BOOST
CD SYNCHRO STA
R
Switching the set on and off
BASIC FUNCTIONS RADIO
INSTRUCTION FOR USE