Service manual

2-7
CS 49 108
CASSETTE RECORDER
11
1 Set the POWER slider to CD. 2 Insert a CD and, if desired, program the track numbers.
3 Press STOP·OPEN 9 / to open the cassette compartment.
4 Insert a blank, unprotected, cassette and close the cassette
compartment.
5 Press RECORD 0 to start recording.
™ Playing of the CD or program starts automatically.
6 For brief interruptions press PAUSE ;. Press the PAUSE ; key
again to resume recording.
7 To stop recording, press STOP·OPEN 9 /.
Note: the recording can be started from different positions:
– if the CD player is in pause mode, recording will start
from this very position (use
∞
or
§
);
– if the CD player is in stop mode, recording will start from
the beginning of the CD or program.
1 Tune to the desired radio station (see ”RADIO”). 2 Press STOP·OPEN 9 / to open the cassette compartment.
3 Insert a blank, unprotected, cassette and close the cassette
compartment.
4 Press RECORD 0 to start recording.
5 For brief interruptions press PAUSE ;. To resume recording press
the PAUSE ; key again.
6 To stop recording, press STOP·OPEN 9 /.
Recording from the radio
PAUSE
STOP•REC
ORD
SEARC
H
PLA
Y
RECORD
OPEN
C
D SYNCHRO START RECORDING
Recording from the CD player – CD synchro start
English
TROUBLESHOOTING
13
Problem Possible cause Solution No sound, VOLUME is not adjusted. Adjust volume. no power
Headphones are connected. Disconnect headphones.
Mains cable is not securely connected. Connect mains cable properly. Batteries are flat. Insert fresh batteries. Batteries are inserted incorrectly. Insert batteries correctly.
Trying to change over from mains to Remove the mains plug from the
battery supply without removing the plug. unit’s AC MAINS socket.
No reaction to Electrostatic discharge. Disconnect the set from power supply,
operation of any keys reconnect after a few seconds. Poor radio reception Weak radio signal. Direct the antenna for optimum
reception.
Interference caused by electrical equipment Keep the radio away from electrical
like TVs, computers, engines, etc. equipment.
no or E indication The CD is badly scratched or dirty. Replace or clean the CD.
No CD is inserted. Insert a CD. The CD is inserted upside down. Insert CD with label facing up. The laser lens is steamed up. Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty. Replace or clean the CD.
SHUFFLE or PROGRAM is active. Switch off SHUFFLE or PROGRAM.
Poor cassette Dust and dirt on the heads, capstans or Clean heads, capstans, and pressure
sound quality pressure rollers. rollers.
Use of unsuitable cassette types Only use NORMAL type cassettes for
(METAL or CHROME) for recording. recording.
Recording does Cassette tab(s) may be snapped off. Apply a piece of adhesive tape over not work the opening.
English
WARNING Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service center.
INSTRUCTION FOR USE