User Guide

18
English
AZ 2030-35 /17 page 18
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REMEDY
No sound/power
VOLUME not adjusted
Adjust the VOLUME
Headphones connected
Disconnect headphones
Power cord not securely connected
Connect the AC power cord properly
Batteries dead/ incorrectly inserted
Insert (fresh) batteries correctly
Severe radio hum or noise
Electrical interference: set too close to TV,
VCR or computer
Increase the distance
Poor radio reception
Weak radio signal
FM: Direct the FM telescopic antenna for
optimum reception
indication
No CD inserted
Insert a CD
CD badly scratched or dirty
Replace/ clean CD, see
MAINTENANCE
Laser lens steamed up
Wait until lens has cleared
indication
CD-R(W) is blank or the disc is not finalized
Use a finalized CD-R(W)
CD badly scratched or dirty
Replace/ clean CD, see
MAINTENANCE
The CD skips tracks
CD is damaged or dirty
Replace or clean the CD
SHUFFLE or PROGRAM is active
Switch off SHUFFLE/ PROGRAM
Poor cassette sound quality
Dust and dirt on the heads, etc.
Clean deck parts etc., see
MAINTENANCE
Use of incompatible cassette types (METAL
or CHROME).
Only use NORMAL (IEC I) for recording.
Recording does not work
Cassette tab(s) may be broken
Apply a piece of adhesive tape over the
missing tab space.
Remote control does not function properly
Batteries dead/ incorrectly inserted
Insert (fresh) batteries correctly
Distance/ angle between the set too large
Reduce the distance/ angle
Remote sensor obstructed by object, sticker
etc.
Remove obstruction/ make sure right hand
side of cassette door is free from obstruction
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
The type plate is located on the bottom of the set.
XP AZ 203x/17.2 09-01-2001 15:25 Pagina 18