Operation Manual

23EN
2 Select [SERVICES] > [RECALL TIME],
then press MENU/OK to conrm.
3 Select an option, then press MENU/OK to
conrm.
» The setting is saved.
Dial mode
Note
This feature only applies to models that support both
tone and pulse dial.
Dial mode is the telephone signal used in your
country. The phone supports tone (DTMF) and
pulse (rotary) dial. Consult the service provider
for detailed information.
Set the dial mode
1 Press MENU/OK.
2 Select [SERVICES] > [DIAL MODE], then
press MENU/OK to conrm.
3 Select a dial mode, then press MENU/OK
to conrm.
» The setting is saved.
Note
If your phone is in pulse dial mode, press during a
call for temporary tone mode. Digits entered for this
call are then sent out as tone signals.
Auto clock
Note
This service is network dependent.
Make sure you have subscribed to the caller ID service
before you use this feature.
It synchronizes the date and time on your
phone with the public switched telephone
network (PSTN) automatically. For the date to
be synchronized, make sure the current year is
set.
1 Press MENU/OK.
2 Select [SERVICES] > [AUTO CLOCK],
then press MENU/OK to conrm.
3 Select [ON]/[OFF], then press MENU/OK.
» The setting is saved.
Register additional handsets
You can register additional handsets to the base
station. The base station can register up to 4
handsets.
1 Press and hold on the base station for
5 seconds.
2 Press MENU/OK on the handset.
3 Select [SERVICES] > [REGISTER], then
press MENU/OK to conrm.
4 Enter the system PIN. Press REDIAL/C to
make corrections. Then press MENU/OK
to conrm the PIN.
» Registration is complete in less than 2
minutes. The base automatically assigns
a handset number to the handset.
Note
If the PIN is incorrect or no base is found within a
certain period, a notication message is displayed on
the handset. Repeat the above procedure if registration
fails.
The preset PIN is 0000. No change can be made on it.
Unregister the handsets
If two handsets share the same base station, you
can unregister a handset with another handset.
1 Press MENU/OK.
2 Select [SERVICES] > [UNREGISTER],
then press MENU/OK to conrm.