User Manual

Firmware Upgrade DVDR3300H / DVDR3330H / DVDR5330H
Firmware Upgrade
This firmware version improves following items:
1. Improved power consumption in standby mode.
2. VideoPlus for country selection Ireland.
3. Improved stability during DVD disc navigation and trick modes
4.
Timer list is not deleted via upgrade stability
5.
stable audio output for DV recording for certain camcorder
Upgrade Procedure
STEP 1 Check your current firmware version
1 Press SETUP on the remote control.
2 Select ‘Features’ and press RIGHT (>).
3 Press following key combination: 1 5 9 6
4 The Platform Version Information screen will appear. Write down the information found on the third line, such as
‘BASE FF13’ (BASE + up to 4 character version name).
STEP 2 Download Firmware upgrade
Download the software and save on your computer.
DVDR3300H DVDR3330H DVDR5330H version FF15A
Click and save it to your computer.
STEP 3 Burning Upgrade on CD-R / CD-RW
1 Extract the files by unzipping the zipped file.
2 Write the extracted files – not the zipfile – onto a blank CD-R or CD-RW disc,
using the following settings:
- File System CD-ROM Joliet
- File name length : max 31 chars (ISO Level 2)
- Mode : 2/XA
- Character set : ASCII
- Single session
- Write Speed : Low
3 Finalize the disc. (The application may do this automatically.)
STEP 4 Apply Upgrade to your DVD Recorder
Insert the CD-ROM and press OPEN/CLOSE. The firmware will start to install on the recorder automatically. During
the upgrade process, it is normal that the recorder will turn off and on occasionally. The process can take up to 10
minutes until the disc is ejected. Caution! The power supply must not be interrupted during firmware upgrade!
1 Press OPEN/CLOSE to open the tray.
2 Insert the upgrade CD-ROM disc, label side up.
3 Press OPEN/CLOSE to close the tray. First “READING” appears on the display,
followed by “WAIT” and “DOWNLOAD”.
NOTE: This stage of the procedure takes about 10 minutes.
If the firmware was already upgraded, the display will show “SYS OK” within a minute and the disc will be ejected.
4 When the upgrade is completed the tray will open automatically.
5 Now remove the disc.
6 Press STANDBY-ON to switch off the recorder.
Your product is successfully upgraded!