Manual

Trimming
> Make sure hair is clean and dry.
> Always comb the hair with the styling comb
in the direction of growth before you start
trimming.
Do not move the Groomer too fast. Make smooth
and gentle movements.
Trimming your Beard & Moustache
with AccuControl Guide Comb
Attachment
I Use this Groomer for its intended household
use as described in this manual.
> Make sure that the Groomer is fully charged
before you start trimming. This Groomer will
not operate while cord is connected to
electrical outlet.
H Put the AccuControl comb on the full width
trimmer attachment until you hear it click
into place (fig. 4).The AccuControl comb
will not work with the smaller neckline
and sideburn trimmer, or mini shaver
attachments.
u Press the Hair Length Selector and slide
it to the desired trimming length setting.
The selected setting number will appear in
the window to the left of the Hair Length
Selector (fig.5). See Table I for settings.
> If you are trimming for the first time, start by
using the AccuControl comb at the maximum
trimming length setting (#9) to prevent
accidentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Selector to desired trimming length.
Selector will “click” into position at each
setting.
B Switch the Groomer ON.
□ To trim in the most effective way, move
the Groomer against the direction of hair
growth. Make sure the surface of the Guide
Comb always stays in contact with the skin
(fig-6).
NOTE: Since all hairs do not grow in the same
direction, you may want to try different trimming
directions fi.e., upwards, downwards, or across!
Practice is best for optimum results.
> If a lot of hair has accumulated in the Guide
Comb, remove the comb and blow and/or
shake the hair out of the comb.You can also
use the cleaning brush provided to remove
hair from the comb area,
k REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the guide comb on the
appliance.