GC1421, GC1420 A B E F C D G 2 3 4 5 6 7 8 9 10 11
English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. General description (Fig. 1) A B ----C D E F G Cap of filling opening Steam control 1 = minimum steam 2 = maximum steam t= no steam u= Calc-Clean function Temperature light Mains cord Water tank Soleplate Temperature dial Important Read this user manual carefully before you use the appliance and save it for future reference.
5 Unplug the iron when the temperature light goes out. 6 Hold the iron over the sink and set the steam control to the Calc-Clean position . 7 Hold the steam control at the Calc-Clean position and gently shake the iron until all the water in the tank has been used up (Fig. 8). ,, Steam and boiling water come out of the soleplate. Scale (if any) is flushed out. 8 After you have used the Calc-Clean function, set the steam control to the ‘no steam’ position.
繁體中文 簡介 恭喜您購買本產品並歡迎加入飛利浦!請於 www.philips.
收納 1 拔下產品插頭,並將蒸汽控制鈕設為「無蒸汽」的位置。 2 將水箱內的水倒光。 (圖 9) 3 將電源線捲繞在熨斗捲線裝置上。 (圖 10) 4 將直立在其跟部上的熨斗存放在一個安全且乾燥的地方。 環境保護 -- 電器壽命結束時請勿與一般家庭廢棄物一併丟棄。請將該產品放置於政 府指定的回收站,此舉能為環保盡一份心力。 (圖 11) 保固與服務 若您需要相關服務或資訊,或是有任何問題,請瀏覽飛利浦網站,網址為 www.philips.
简体中文 产品简介 感谢您的惠顾,欢迎光临飞利浦!为了您能充分享受飞利浦提供的支持,请 注册您的产品,网址为 www.philips.
4 将电源插头插入插座。 5 当温度指示灯熄灭时,拔下熨斗的电源插头。 6 在水池上方手持熨斗,并将蒸汽控制旋钮设定到除水垢位置 。 7 将蒸汽控制旋钮保持在除水垢位置并轻轻摇晃熨斗,直到水箱中的水全 ,GC1421 部排完。 (图 8) ,, 蒸汽和沸水会从底板冲出。水垢(如果有的话)也一并冲出。 8 使用了除水垢功能之后,请将蒸汽控制旋钮设置到“无蒸汽”位置。 ,GC1421 9 如果从熨斗中冲出的水仍有水垢颗粒,则应再次使用除水垢功能。 完成除水垢过程后 1 插上熨斗的插头,让底板变干。 2 当温度指示灯熄灭时,拔下熨斗的电源插头。 3 将熨斗放在一块用过的布上轻轻地前后移动,以除去留在底板上的水 渍。 4 让熨斗冷却,然后存放好。 存放 1 拔下产品的电源插头并将蒸汽控制旋钮设置到“无蒸汽”位置。 2 倒空水箱。 (图 9) 3 将电源线绕在存线装置上。 (图 10) 4 请将熨斗竖放在安全干燥的地方。 环境 -- 弃置产品时,请不要将其与一般生活垃圾堆放在一起;应将其交给官方 指定的回收中心。这样做有利于环保。 (图 11) 保修与服务 如果您需要服务或信息,或者有任何疑问,请访问飞利浦