User manual

21
Problem Possible cause Solution
EN
The ironing board cover be-
comes wet.
Steam has condensed on the
ironing board cover after a long
ironing session.
Replace the ironing board cover if the foam
material has worn out. You can also add an extra
layer of felt material under the ironing board
cover to prevent condensation on the ironing
board.
Water droplets come out of the
soleplate.
The steam that was still present
in the hose has cooled down and
condensed into water.
Point the iron away from the garment and let it
produce steam for a few seconds.
Steam and/or water comes out
from under the EASY DE-CALC
knob.
The EASY DE-CALC knob is not
tightened properly.
Switch off the appliance and wait for two hours
for steam generator to cool down. Unscrew the
EASY DE-CALC knob and reattach it properly.
Note: When you remove the knob, water comes
out of the steam generator. If steam continues to
escape, switch off the appliance and contact an
authorised Philips service centre.
Dirty water and impurities come
out of the soleplate.
Impurities or chemicals present
in the water have deposited in
the steam vents and/or on the
soleplate.
Clean the soleplate. See
.
Too much scale and minerals have
accumulated inside the steam
generator.
Descale the steam generator regularly. See
EASY
DE-CALC
.
The iron leaves a shine or an
imprint on the garment.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a
fold in the garment.
PerfectCare is safe on all garments. The shine or
imprint is not permanent and will come off if you
wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the
area to be ironed to avoid imprints at seams
and folds.
The steam generator does not
produce any steam.
There is not enough water in
the water tank (the ‘water tank
empty’ light ashes).
Fill the water tank.
The steam generator is not hot
enough to produce steam.
Wait until the ‘iron ready’ light on the iron lights
up continuously.
You did not press the steam
trigger.
Press the steam trigger and keep it pressed while
you iron.
The water tank is not placed
properly in the steam generator.
Slide the water tank rmly back into the steam
generator (‘click’).
The steam generator produces a
pumping sound.
Water is pumped into the boiler
inside the steam generator. This
is normal.
If the pumping sound continues non stop, switch
off the steam generator and remove the plug
from the wall socket. Contact an authorised
Philips service centre.