User Guide

25
ENGLISH
24
Technical Specifications (1)
System
Output power 2 x 5mW (16 Ω)
Frequency response 20-20.000 Hz
THD 0.01%- 0.1%
lens hardened optical glass
casing material magnesium
Connections
Headphone & remote control
USB 2.0 (USB 1.1 compatible)
DC power supply
Combined analogue / digital input: SPDIF
Display
0 4-level grey scale 160 x128 pixels
0 white backlight LED
Storage
Hard disk Low profile 1.8" hard disk
Capacity 15GB (HDD100),
* Actual formatted capacity of hdd will be less
Supported playback format
MP3 8- 320 Kbps, MP3 Variable Bit Rate (VBR)
WMA 32- 192 Kbps
ID3-tag support Yes
MP3 Audio recording
Voice recording (MP3) Via built-in microphone (mono,64Kbps)
Audio recording (MP3) Via 3.5mm line-in jack (stereo)
Analog (64/128/192 Kbps)
Digital optical (64/128/192 Kbps)
Copyright Information
0 Unauthorized duplication and distribution of Internet/CD recordings violate
copyright law and international treaties.You should use hdd and PHILIPS Digital Media
Manager (DMM) software for personal use only.
0 In the U.K and certain countries, the copying of material protected by copyright
may require the permission of the copyright holders.
Philips hdd100
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual,may cause harmful interference
o radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
ause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
0 Relocate the receiving antenna.
0 Increase the separation between the equipment and receiver.
0 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
0 Consult the dealer or an experienced radio/ TV technician for help.
Notice for the USA
Modifications
Modifications not authorized by the manufacturer may void users authority to operate this
device.