User Guide

4
English
• To enable recycling, the plastics of
the product have been coded.
• The cardboard packaging has been
made of recycled material and is entirely
suitable for recycling.
Important
• Before using for the first time, check
if the dustbag is placed correctly.
• Never suck up water (or any other
liquid). Never pick up ashes until they
are cold.
• When picking up fine dust, the pores
of the dustbag may become clogged.
This will obstruct the air passage.
Subsequently, the dustbag needs
replacement, although the bag might
be far from full.
• Only use this vacuum cleaner with
the original Philips dustbags types
Oslo
+
or Oslo
+
Hygiene (closeable).
• Never use the vacuum cleaner
without the motor protection filter.
f
Please note that * in the illustration numbers
means: this illustration applies to special models
only.
Getting the vacuum cleaner ready for use:
• Connecting the hose: press firmly
("Click!") (fig. 1a).
- To disconnect: press the knob and pull the
hose out of the vacuum cleaner (fig. 1b).
• Connecting the nozzle, the telescopic
tube and the handle: insert the narrowed
section into the wider section while rotating a
little (fig. 2).
- To disconnect: pull while rotating.
• To adjust the telescopic tube to the
required length, pull the locking knob in the
direction of the arrow (fig. 3) while sliding the
top section of the telescopic tube in or out
the lower section. Then release the knob
• Nozzles:
- Combi nozzle.
- Small nozzle, brush nozzle and crevice
nozzle. These can be found in the special
storage compartment (fig. 4-8);
• Pull the mains plug out of the vacuum
cleaner (fig. 9) and insert into the wall socket.
• Press the on/off switch (I) (fig. 10).
• The electronic suction power control on
the vacuum cleaner enables smooth suction
power adjustment (fig. 11).
MAX = maximum suction power.
MIN = minimum suction power.
- Move the slide towards MAX until the
desired suction power is obtained.
Medium suction power is advisable for
general use.
Minimum suction power is advisable for
dusting using the brush nozzle and for cleaning
curtains, cloths, etc.
Maximum suction power is advisable for
cleaning very dirty carpets and hard floors.
• The suction power control at the hand
grip enables you to reduce suction power
(fig. 12). This extra facility is advisable if you
wish to apply lower suction power for a short
period.
Insufficient suction power?
Please check:
- if the slide on the vacuum cleaner is in the
required position;
- if the control at the hand grip is in "open"
position;
- if the dustbag is full;
- if the nozzle, tube or hose is blocked up.
To remove the obstruction, disconnect the
blocked-up item and connect it (as far as
possible) in adverse position. Then the air will
stream through the item in opposite direction.
Park
If you wish to interrupt vacuum cleaning, you
can place the tube clip into the rest (fig. 13).
You can slide the clip along the tube to change
the height.