DVD Player User Manual

16
9 Troubleshooting
Warning
Risk of electric shock. Never remove the
casing of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of your product. The
model number and serial number are on the back
or bottom of your product. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this home theater do not work.
Disconnect the home theater from the
power outlet for a few minutes, then
reconnect.
Picture
No picture.
Ensure that the TV is switched to the
correct source for this home theater.
If this happens when you change the TV
system, switch to its default mode: 1) Press
to open the disc compartment. 2) Press
the Numeric buttons ’3’ .
If this happens when you switch on the
progressive scan mode, switch to its
default mode: 1) Press
to open the
disc compartment. 2) Press the Numeric
buttons ’1’ .
No picture on HDMI connection.
Check if the HDMI cable is faulty. Replace
with a new HDMI cable.
If this happens when you change the HDMI
video resolution, switch to its default mode:
1) Press
to open the disc compartment.
2) Press the Numeric buttons ‘1 .
Speakers
System: full range satellite
Speaker impedance: 8 ohm (center), 4 ohm
(Front/Rear)
Speaker drivers: 3” full range
Frequency response: 150 Hz-20 kHz
Dimensions (WxHxD):
Center: 160.9 x 95 x 92 (mm)
Front: 95 x 160.9 x 87 (mm)
Rear: 254 x 1001.5 x 254 (mm)
Weight:
Center: 0.77 kg
Front: 0.56 kg/each
Rear: 3.25 kg/each
Cable length:
Center: 2 m
Front: 3 m
Rear: 10 m
Laser speci cation
Type: Semiconductor laser GaAIAs (CD)
Wave length: 645 - 665 nm (DVD), 770 -
800 nm (CD)
Output power: 6 mW (DVD), 7 mW
(VCD/CD)
Beam divergence: 60 degrees.
EN